STAS windsor - 47.24 inch/120 cm

Our wooden rails are made out of Ayous wood and are FSC and PEFC certified. Ayous wood differs from other, cheaper wood since it does not deform nor splinter. The STAS windsor is available in natural and in white and, thanks to the smooth texture of the wood, it is extra easy to paint over in the colour of your choice. Perfect wood for your picture hanging system! Can be mounted with screws, nails and glue*.

Experience the pleasant warmth of wood in your interior!

* The bearing capacity of a glued rails is highly dependent on the surface, so care must be taken here. More information on how to best glue our wooden rails can be found at the bottom of this page.

We are using timber from sustainably managed forests.where trees are replanted as they are felled.
STAS maintains strict quality control regarding the wood – the rails are perfectly straight and very well dried.

The high quality Ayous wood differs from other, cheaper wood types:
It can handle temperature and humidity changes very well – so it won't warp or splinter as easily as other, cheaper wood type rails such as pine.

STAS windsor has its own collection of hooks, which can be combined with the existing hooks and cords from STAS:

STAS windsor:
HW10200 white
HW30200 alu
HW60200 gold

The following hooks and cords can be used in combination with this system:
STAS smartspring on STAS perlon cord with loop (can be loaded up to max. 8.8 lbs/4 kg)
STAS zipper on STAS perlon cord with loop (can be loaded up to max. 33 lbs/15 kg)
STAS zipper on STAS steel cable with loop (can be loaded up to max. 44 lbs/20 kg)

5-Step Plan for glueing the STAS windsor

Step 1: Assess the surface

When glueing the STAS wooden rails it's very important that the surface is well fixed and firm. This goes especially for wall paper. The wall paper must have been applied tightly and evenly to allow the STAS wooden rails to adhere as well as possible.

Step 2: Pick the right glue.

We recommend a glue that is especially designed to offer a very good adhesion on wooden surfaces. We advise you to go see your local DIY store for further recommendations.

Step 3: Pretreatment

Make sure that the surface and the STAS wooden rails are clean, dry, dust- and grease free before you start glueing.

Step 4: Glueing

The glue can best be applied in strokes (so don't cover the whole rails in glue). Once the glue is applied you can place the STAS wooden rails on its surface (make sure it's level!). The STAS wooden rails can at this point still be adjusted. When the rails are in the right place you can exert pressure so that the STAS wooden rails is well attached to the surface. Then allow the glue to dry for 24 hours.

Step 5: Hang your wall decoration

Hang your favorite wall decoration using the STAS hooks and cords and admire the result!